manual secadora electrica general electric

31-16775-4 02-20 GEA Questions? Call GE Appliances at 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances. Service information and the wiring diagram are located in the control console.Remove and discard existing plastic or metal foil duct and replace with UL-listed duct.Install the dryer where the temperature is above 50☏ for satisfactory operation of the dryer control system.Product failure due to improper installation is not covered under the Warranty.Proper installation is the responsibility of the installer.Close supervision of children is necessary when the appliance is used near children. Do not allow children on or in the appliance.

Before the old dryer is removed from service or discarded, remove the dryer door.This dryer must be exhausted to the outdoors.En la parte de atras de la secadora General Electric del año 1994 me da la opcion de cambiarla de 220 a 110 pero no se como hacerlo y se me perdio con el tiempo el manual de instalacion donde me daba la opcion y las instrucciones de. Note to Consumer – Keep these instructions for future reference. En esta oportunidad expreso mi desespero por que quiero ayuda acerca de como cambiar mi secadora de 220 a 110.Note to Installer – Be sure to leave these instructions with the Consumer.Install the clothes dryer according to the manufacturer’s instructions and local codes.IMPORTANT – Observe all governing codes and ordinances. IMPORTANT – Save these instructions for local electrical inspector’s use.

FOR GAS DRYERS ONLY BEFORE YOU BEGIN Read these instructions completely and carefully.

A flexible gas connector, when used, must not exceed 4 feet.

If using a ball valve, it shall be a T-handle type.

Installation must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the State.

(Installers: Be sure to leave these instructions with the customer.) In the Commonwealth of Massachusetts, the following installation instructions apply:

To reduce the risk of severe injury or death, follow all installation instructions.

DO NOT install or store this appliance in any location where it could be exposed to water or weather.

These conditions will obstruct dryer airflow and increase the risk of fire. Flexible venting materials are known to collapse, be easily crushed and trap lint. If flexible metal (semi-rigid or foil-type) duct is installed, it must be UL-listed and installed in accordance with the instructions found in “Connecting the Dryer to House Vent” later in this manual.

DO NOT install a clothes dryer with flexible plastic venting materials.

Install the clothes dryer according to these instructions and local codes.

Clothes dryer installation must be performed by a qualified installer.

Manual secadora electrica general electric